LEAD VISE, SPRING LOADED GLASTAR This fine spring loaded vise clamps the lead came securely for stretching. Bolts to work bench. Grabs firmly during stretching!  Unit: EACH	TLS2000	[ 0.4 lb. ]
		LEAD VISE, without SPRING Imported economical lead vice for holding cames while stretching. Screws into edge of work bench.  Unit: EACH	TLW3000	[ 0.4 lb. ]
		$ Stanton LEAD STRETCHER This is NOW ON SALE ($) at shown price. GLASTAR Designed to fit any type of bench surface. Includes a regular lead vice to hold other end (now included). Lever makes stretching lead cames easy!  Unit: EACH	TLG1000	[ 3.3 lbs. ]
		HAMMER, DOUBLE FACED Leading hammer. Has soft rubber on one end for tapping glass, and hard plastic on other end for pounding nails.  Unit: EACH	TLH3000	[ 0.7 lb. ]
		HORSESHOE NAILS Traditional way to hold leaded projects in place as you build. Flat surface of nail prevents gouges in lead or chips in glass. Sold in box of 100 nails.  Unit: BOX	TLN2000	[ 1 lbs. ]
		FAN OUT LEAD DIKES 6” adjustable lead dike (Nippers) that makes clean cuts every time, unlike cheaper ones. Spring loaded for ease of use. Very long lasting, high quality.  Unit: EACH	TLD5252	[ 0.4 lb. ]
		LEAD DIKES, Classic American CLASSIC AMERICAN Lead Dikes....low cost but high quality... Not a cheap generic like others carry. Comfortable textured rubber coated grip. 6 in. Imported.  Unit: EACH	TCA1010	[ 0.4 lb. ]
		LEAD DIKES, Dragon DRAGON BRAND Lead Dikes. SPECIAL BUY...low cost but high quality. Comfortable textured rubber coated grip. 6 in. Imported.  Unit: EACH	TCA1013	[ 0.4 lb. ]
		LP-1 LEAD DIKE Inexpensive lead dike (nipper) for cutting lead quickly and cleanly. Looks similar to regular wire cutter, but they are not! These are specially made to make a clean flat cut on lead cames. (Don't let friends use as wire cutter -- it will dull the special blade.)  Unit: EACH	TLD6363	[ 0.4 lb. ]
		LEAD KNIFE, PRO BRAND Stainless steel blade and weighted handle. Vertical design provides good leverage. Try wiggling it sideways as you cut through lead for easier cutting. Made in Taiwan.  Unit: EACH	TLK2525	[ 0.4 lb. ]
		LIL' NOTCHER, 90 degree Angle Cuts a perfect notch on both sides of 1/8" U channel zinc, brass or copper cames for easing bending around 90 deg. corners. Only for cames MBU-,MZU-, or MCU1250.  Unit: EACH	TLN9000	[ 0.8 lb. ]
		$ Zinc, Brass Came BENDER This is NOW ON SALE ($) at shown price. This unusual bending maching bends both U channels and H channel up to 3/4" wide. Bends into an arc or even a full circle. Fully adjustable for various came sizes. Mounts on work bench for stability.  Unit: EACH	TCB3345	[ 6.8 lbs. ]